Kenwood KAC-PS810D Instruction Manual page 7

Connection
■ Terminal names
! Fuse (25 A × 3)
@ Battery terminal
# Ground terminal
% Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
2CAUTION
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
^ RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
& LINE IN terminal
* LINE OUT terminal
The signal that's input from the line input
terminal is output.
POWER IN
SPEAKER
BATT. P.CON
OUTPUT
! @ # $
B.M.S. BAND REJECT PHASE INFRASONIC
–6dB
OFF
REVERSE OFF ON 15Hz
NORMAL
REMOTE +12dB OFF –12dB
GND
^
%
LINE IN LINE OUT EXT.AMP.CONT.
25Hz
L L
R R
& * (
$ Power control terminal
Controls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it
with all the systems.
( EXT.AMP.CONT. (external
amplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
NOTE
There are cases when operation may not be
possible due to wiring wire type and length.
7
English