Attenuator; Audio Control; Audio Setup; Bass Boost - Kenwood KDC-W237 Instruction Manual

General features

Attenuator

Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, the "ATT" indicator
blinks.

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Subwoofer level* "SW L"
System Q "NATURAL"/"ROCK"/
"POPS"/"EASY"/
"TOP40"/"JAZZ"
Bass level "BAS L"
Middle level "MID L"
Treble level "TRE L"
Balance "BAL"
Fader "FAD"
Exit Audio Control mode (Volume control mode)
⁄
About System Q
• You can recall the best sound setting preset for different
types of music.
• Change each setting value with the <Speaker Setting>
(page 9). First, select the speaker type with the Speaker
setting.
• "USER": This appears when Bass level, Middle level,
and Treble level are adjusted. When "USER" is
selected, these levels are recalled.
• *Function of KDC-W4037
5
Exit Audio Control mode
Press any button.
|
8
English

Audio Setup

Setting the Sound system, such as Volume offset.
1
2
3
4
Range
–15 — +15
Natural/Rock/Pops/Easy/
Top 40/Jazz
5
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15

Bass Boost

Bass sound can be enhanced by one-touch
operation.
Press a button other than the [VOL] knob and [ATT]
button.
Select the source to adjust
Press the [SRC] button.
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
Adjust the Audio setup item
Turn the [VOL] knob.
Adjustment Item Display
Low Pass Filter* "LPF"
Volume offset "V-OFF"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• *Function of KDC-W4037
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Press the [B.BOOST] button.
When you press the button once, the current Bass
Boost setting is displayed.
Each time you press the button, the Bass Boost
setting alternates.
Setting
Bass Boost 1
Bass Boost 2
Bass Boost off
Range
80/120/160/Through Hz
–8 — ±0 (AUX : –8 — +8)
Display
"BB-L L1"
"BB-L L2"
"BB-L OFF"