Connecting Wires To Terminals - Kenwood KDC-W237 Instruction Manual

Connecting Wires to Terminals

Fuse (10A)
Wiring harness
(Accessory1)
To Steering remote
(KDC-W4037/KDC-W3537 : Western European countries sales area only.)
To Kenwood disc changer/ External optional accessory
(KDC-W4037/KDC-W3537 only)
FM/AM antenna input
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
To connect these leads, refer to the relevant
instruction manuals.
Antenna Cord (ISO)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Rear left output / Sub Woofer left output (White)
Rear right output / Sub Woofer right output (Red)
(KDC-W4037 only)
Connect to the terminal that
is grounded when either the
telephone rings or during
conversation.
Connect either to the power
control terminal when using the
optional power amplifier, or to
the antenna control terminal in
the vehicle.
To connect the Kenwood
navigation system, consult
your navigation manual.
|
29
English