Sharp UX-8 Service Manual page 8

UX-8TH/UX-40TH
GQ-5TH/FO-50TH
4. Loading the fax paper (FO-20PRw)
• Your fax machine prints incoming faxes on a special kind of paper
called fax paper.
• The fax machine's print head creates text and images by applying
heat to the fax paper.
1
Grasp the finger hold as shown and pull up to open the operation
panel.
2
Flip up the front paper guide.
3
If you are loading A4 size paper, place the paper roll shims on each
side of the paper compartment.
• The ribbed side of the shims should face in (toward each other).
4
Unwrap the roll of fax paper and insert the paper shaft.
5
Place the roll of fax paper in the compartment, making sure the ends
of the paper shaft fit into the notches on each side of the compart-
ment.
♦ Important: The roll must be placed so the leading edge of the
paper unrolls as shown. (The paper is only coated on one side for
printing. If the roll is placed backwards, the paper will come out
blank after printing.)
YES
NO!
6
Insert the leading edge of the paper into the slot as shown. Continue
to push the paper through the slot until it comes out the opening in
the front of the machine.
7
Make sure the paper comes out straight, and then flip down the pa-
per guide.
8
Close the operation panel, making sure it clicks into place.
• A short length of the paper will feed out. Grasp the paper by the
edge and pull upward to tear it off.
Click!
1 – 6