Sawdust; Lubrication - Craftsman 137.407530 Operator's Manual

SAWDUST
Periodically, sawdust will accumulate
under the work table and base. This
could cause difficulty in the movement
of the worktable when setting up
a miter cut. Frequently blow out or
vacuum up the sawdust.
If need to remove small pieces of
material from the table cavity, see the
section on Removing and Installing the
Table Insert on page 21.
To empty the dust bag, remove the
sawdust bag from the dust port. Open
the zipper on the sawdust bag and
empty out the sawdust inside. Close
the zipper and reinstall the dust bag on
the dust port as described on page 18.
l,_ WARNING l
Wear proper eye protection to keep
debris from entering eyes when
removing sawdust from unit.
LUBRICATION (FIG. UU)
All the motor bearings in this tool are
lubricated with a sufficient amount of
high grade lubricant for the life of the
unit under normal operating conditions;
therefore, no further lubrication
is required.
Lubricate the following as necessary:
Chop pivot: Apply light machine oil to
points indicated in illustration.
Central pivot of plastic guard: Use light
household oil (sewing machine oil) on
metal-to-metal or metal-to-plastic guard
contact areas as required for smooth,
quiet operation. Avoid excessive oil, to
which sawdust will cling.
Fig. UU
Central pivot of
plastic guard (oil here)
\
Chop Pivot (oil here
and on opposite side)