Hazard Warning Flashers; Turn And Lane-Change; Signals - Chevrolet 2011 Colorado Owner's Manual

6-4 Lighting

Hazard Warning Flashers

(Hazard Warning Flasher):
Press this button located on the
instrument panel, to make the front
and rear turn signal lamps flash on
and off. This warns others that you
are having trouble.
Press again to turn the
flashers off.
The turn signals do not work while
the hazard warning flashers are on.

Turn and Lane-Change

Signals

Move the lever all the way up or
down to signal a turn.
Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Hold it there until the lane
change is complete.
The lever returns to its starting
position when it is released.
I n f o r ma t i o n P r o v i d e d b y :
If after signaling a turn or a lane
change the arrows flash rapidly or
do not come on, a signal bulb may
be burned out.
Have the bulbs replaced. If the bulb
is not burned out, check the fuse.
For bulb replacement, see
Taillamps, Turn Signal, Stoplamps,
and Back-Up Lamps on page 10 37.
For a blown fuse or circuit breaker,
see Fuses and Circuit Breakers on
page 10 40.
Turn Signal On Chime
If a turn signal is left on for more
than 1.2 km (3/4 of a mile), a chime
will sound at each flash of the turn
signal and the message TURN
SIGNAL will also appear in the DIC.
To turn the chime and message off,
move the turn signal lever to the off
position.
See TURN SIGNAL under Lamp
Messages on page 5 25 for more
information.