Main Circuit Breaker - Pride Rally Owner's Manual

Table of Contents

Advertisement

n The fuse is located under a cap on the outside of the battery charger.
n The cap unscrews to allow access to the fuse.
n Unscrew the cap and replace the fuse if it has blown.
CAUTION! The replacement fuse must exactly match the rating of the new fuse. If you install a
fuse with an incorrect rating, you may damage the charger. Contact your authorized Pride provider
for fuse rating information.
Batteries
The batteries store the electrical energy that powers your Rally. See V. “Batteries and Charging.”
Electronic Controller Assembly
The electronic controller assembly is located behind the batteries and at the forward left corner of the
Rally’s rear section. This assembly receives electrical signals from the console controls and sends power to
the motor, the brakes, and the optional lighting system.

Main Circuit Breaker

When the voltage in your Rally’s batteries becomes low or your Rally is heavily strained because of excessive
loads or steep inclines, the main circuit breaker may trip to protect your Rally’s motor and electronics from
damage.
n The main circuit breaker is mounted on the rear section of the Rally, near the manual freewheel lever.
See figure 7.
n The main circuit breaker reset button pops out when the breaker trips.
n When the breaker trips, the entire electrical system of your Rally is shut down.
n Allow a minute or so for your Rally’s electronics to “rest.”
n Push in the reset button to reset the breaker.
n If the breaker trips frequently, you may need to charge your batteries more often. You may also need to
have your Pride provider perform a load test on your Rally’s batteries.
n If the main circuit breaker trips repeatedly, see your authorized Pride provider for service.
Manual Freewheel Lever
Whenever you need or want to push your Rally for short distances, you can put it in manual freewheel
mode.
WARNING! Before placing your Rally into or taking it out of freewheel mode, make certain that the
key is removed from the key switch. Even though the motor of your Rally is disengaged from the
drive system when your Scooter is put in manual freewheel mode, the motor can still run if the
throttle lever is pushed. Never sit on a Scooter when it is in freewheel mode. Never put a Scooter
in freewheel mode on an incline.
n The manual freewheel lever is located on the end of the motor/transaxle assembly at the left rear of the
Rally, and extends through the rear shroud. See figure 7.
n Pull up on the manual freewheel lever to disable the drive system and the brake system.
n You will then be able to push your Rally.
n Push down on the manual freewheel lever to reengage the drive system and the brake system and to
take your Rally out of freewheel mode.
14
I V .
D E S C R I P T I O N
Rally

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents