ZyXEL Communications VMG892-B10A User Manual page 110

Chapter 7 Home Networking
Click Apply to save your settings.
3
Figure 55 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 30 Network Setting > Home Networking > LAN Setup
LABEL
Interface Group
Group Name
LAN IP Setup
IPv4 Address
Subnet Mask/
Prefix Length
IGMP Snooping
Status
IGMP Mode
DHCP Server State
DHCP
DHCP Relay
Server Address
110
DESCRIPTION
Select the interface group name for which you want to configure LAN settings. See
12 on page 179 for how to create a new interface group.
Enter the LAN IPv4 IP address you want to assign to your Device in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are instructed to
do so.
Select the Enable IGMP Snooping checkbox to allows the Device to passively learn
multicast group.
Select Standard Mode to have the Device forward multicast packets to a port that joins the
multicast group and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to have the Device block all unknown multicast packets from the
WAN.
Select Enable to have the Device act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the Device.
Select DHCP Relay to have the Device forward DHCP request to the DHCP server.
This field is only available when you select DHCP Relay in the DHCP field.
VMG8924-B10A and VMG8924-B30A Series User's Guide
Chapter