Connecting To A Tv With Component Input Terminals; Tv Output Select; Connecting To An Audio Component - Kenwood DVF-3080 Instruction Manual

10

Connecting to a TV with Component input terminals

TV
COMPONENT VIDEO INPUT
C
Y C
B R

Connecting to an Audio component

For playback of DTS audio, please connect an AV receiver or an AV amplifier which can decode DTS by digital con-
nection.
TV
Amplifier equipped with 2-channel analog stereo or Dolby Pro Logic II / Pro Logic:
Connect the left and right AUDIO OUT jacks on the DVD player to the audio left and right IN jacks on your amplifier, receiver, or stereo
system, using the audio cables.
Amplifier equipped with 2-channel digital stereo (PCM) or a multi-channel decoder (Dolby Digital™, MPEG 2, or DTS):
Connect one of the DVD Player's DIGITAL OUT jacks (COAXIAL or OPTICAL) to the corresponding in jack on your amplifier. Use an op-
tional digital (coaxial or optical) cable.
1. In case an associated system component is connected, also read the instruction manual of the component.
2. If the audio format of the digital output does not match the capabilities of your receiver (amplifier), the receiver produces
Notes Notes
a strong, distorted sound or no sound at all.
3. Insert the optical-fiber cable straight into the connector until it clicks.
4. Never bend or bundle the optical-fiber cable.
Audio cord
R L
AUDIO VIDEO
INPUT
Rear panel example
(DVF-8100 for Europe)
Component cords (Commercially available)
R L
AUDIO VIDEO COAXIAL
INPUT DIGITAL INPUT
AV receiver or
AV Amplifier
Video cord or Component cords (Commercially available) (9)
Video cord
COAXIAL R
OUT
AUDIO
Y C
B
OPTICAL
OUT
DIGITAL OUT
COMPONENT VIDEO
(PCM/BIT STREAM)
Audio cord
Coaxial or Optical cable
(Commercially available)
Only DVF-8100 for
Europe
OPTICAL
Rear panel example
(DVF-8100 for Europe)
System Connections
DVF-3080/DVF-8100 (EN/K,P,E,X,Y)
L
OUT
VIDEO
C
R

$ "TV Output Select

(only for Europe)"
COAXIAL R
OUT
AUDIO
Y
OPTICAL
DIGITAL OUT
COMPONENT VIDEO
(PCM/BIT STREAM)
AV
L
OUT
VIDEO
C C
B R
OUT