07 Maintenance and service
Lamps
The headlamp must be mounted and the con-
nector correctly installed before the lighting is
switched on or the remote control key is
inserted into the ignition switch.
Removing the cover
Before starting to replace a bulb, see
page 259.
1. Open the lock clamp by pressing up/out.
2. Press down the clips on the cover and
07
remove it.
Reinstall the cover in reverse order.
260
Dipped beam, halogen
1. Detach the headlamp, see page 259.
2. Remove the cover.
3. Unplug the connector from the bulb.
4. Detach the bulb by pressing the holder
downwards.
5. Fit the new bulb in the socket and snap it
in. It can be secured in one position.
Reinstall the parts in reverse order.
Main beam, Halogen
1. Detach the headlamp.
2. Remove the cover, see page 260
3. Detach the bulb by turning anticlockwise
and then pulling straight out
4. Unplug the connector from the bulb.
5. Replace the bulb and align it in the socket
and turn clockwise in order to secure it. It
can be secured in one position.
Reinstall the parts in reverse order.