Whirlpool thin twin Installation Instructions Manual page 5

-.
-26.
19.
I
To exhaust the dryer straight from
back of the washer/dryer unit or
to either side, determine if any
additlonal exhaust duct is needed
[see exhaust requirements.
Panel A]. To exhaust the dryer
inside see Alternate Exhaust
Methods, Panel E. Connect exhaust
duct to exhaust hood.
Washer fill hoses. drain hose and
electrical mrd can be connected
before movina the washeridrver
into fmal posicon if work spa&
permits. [For installotlon in
recessed, closet or mobile home
locations see Alternate
Installations. Panel E.)
Move the
washer/dryer
to its permanent
location. Put
drain hose in tub
or standpipe and
secure according to
Alternate Methods of
Ribbed Drain Hose, Panel E.
Plug the electrical cord into the
grounded outlet.
,
a carpenter's level and place it
on the top of the washer, first side
to side. then front to back. If you
do not have a level take your
Whirlpool Operating Instructions:
turn to the oaae where the
controls a& 6own. Following
those directions, [open washer lid]
fill the water basket to anv aiven
row of holes, then stop the washer
Check to see if the water meets
the holes all the wav around the
basket. If it does not: screw
the front feet of the washer up or
down to adiust. Then tilt the
machine fo'ward and the back
legs will self-adjust.
I
1 Use duct tap-e to seal all Joints.
B
128
, With the washel
control in the
1 "OFF"position.tumon the water
faucets and check for leaks.
Tighten couplings if necessary.
Also check power cord to make
sure it is not pinched
Attach the hose from the ho
water faucet to the bottom
valve opening (marked "H"
the washer. The cold water
attaches to the top inlet valve
opening [marked "C"]. Tighten
couplings by hand. then make an
additional two-thirds turn with
pliers.
29.
Replace access panel. Be sure to
tighten both screws.
Remove plug from
Place the hose clamp on the
drain connector. Next, take the
drain hose and firmly push the
coupling end over the connector.
Using pliers, open the clamp on
the connector and slide it up and
over the drain hose. Release and
check for good fit. Move the
washer close to its final position.
Put the "hook"end of the drain
hose in the laundry tub or
/
0
4 - -
If the drain hose is too long -
disconnect the drain hose.
Remove the coupling and clamp
from the hose. Estimate how lona
the drain hose should be. Cut th;
flexible end of the hose to the
correct lenath. tDo not cut the
hook&a& end of the drain
hose.) Push and twist the coupling
securely onto the dram hose. (Vou
$ou!d be able to feel the top of
me araln nose
TtVOugh the
couplmg.) Slide the clamp over
the coupling and hose. Re-install
the drain hose as described in
Take out two blocks
between washer and
dryer and place with
other shipping pieces.
Check to see if you have all of
these shipping pieces removed
from the washet/drver. If you don't
remove all the shipping materials,
the washerjdrver mav "walk"
away from its iocatio;l...it3
happened! If you are missing a
shipping piece go back through
the steps to see what you skipped
bV unscrewing 2 phillips
head screws located
at the top of the panel.
Set oanel and screws
siep 21
aside