Whirlpool thin twin Installation Instructions Manual page 4

that come with your Whirlpool
washer/dryer.
10
n
Remove the
packing piece
attached to the
outside of the
washer/dryer
except the two
blocks between
washer and dryer.
between the w&her--d
and dryer until unit is in place.
You should have these pieces:
s 2 front corner pieces
l
2 rear comer oieces
. 1 dryer cover
Untape and open washer lid.
Latch under the dryer will hold lrd
open.
\
Remove foam shrpprng piece.
Now check to see that you have
all these shrpping pieces
Remove hoses and parts
package from rnsrde the washer
Place hoses and other pans by
_
your tools Remove all parts from
the plastic package and check
to see that you have these parts:
l
2 washer hoses
l
Copper
l
drain hose grounding wire
l
grounding
clamp
Now place a flat washer into
each end of the inlet hoses.
[Check to make sure washers are
firmly seated in couplings.]
Attach hoses to faucets. Tighten
couplings by hand. then make a
final two-thirds turn with pliers.
with screw
f
Do no1 remove
the blocks
belween
the washer
and dryer
until unit
is in place.