Whirlpool thin twin Installation Instructions Manual page 3

-.
Now start...
1.
Using a %a inch socket wrench
remove the two bolts holding the
wood pallet to the bottom of the
washer/dryer.
Then remove the pallet. Remove
a11 parts from me plostrc package.
Line these up next to Your tools
so each port is there when you
need rt.
Check to see that you have these
parts
.4 legs
l
1 plastlc strap
l
1 hose clamp
l
4 flat water
3
hose washers
n
Prck up a rear leveling leg: turn
ii so the flat side and pegs fit Into
the hole in the rear corner Push
the leg in until it snaps into place.
Do the same thing with the other
leveling leg in the other rear
corner.
4a
'-a
n
When you have both rear legs in.
push up on one leg; check io see
if the other leg goes down. Check
the other leg in the same way (If
the legs don't adjust as they're
moved, go through step 3 again.)
took for the shipping bolts-these
are the largest bolts and have red
labels beneath the bolt heads.
Using a Yz" wrench, remove only
the two shipping bolts. Do NOT
remove the three smaller bolts as
they are part of the suspension
With one of the front legs in hand.
check the ridges for a dramond
marking. That's how far the leg is
supposedtogointothehole
in the trrangular brace at the front
corner of the machine.
With the washer/dryer still in the
carton stand the washer/dryer
upright.
Because of the weight and JZe Of
the washer/dryer, two people are
Start to screw me front legs into
the hole bv hand. A little liquid
detergent to lubricate the screw
will help. (vou'll need pliers
to turn the leg all the way to the
diamond.)
PANEL B