Table of Contents
Advertisement
6
en | Installing the MON172CL20
2.
Fig. 4.2 Removing the Power Bayonet
3.
Fig. 4.3 Mounting the Device
F01U064552 | 1.0 | 2007.02
Remove the power bayonet connector from the panel (see Figure 4.2 on page 6), while
sliding the base off the monitor.
Mount the unit to the mounting device (not provided) using the four (4) mounting holes
on the rear panel. The square mounting hole patterns are standard on 100 mm (3.9 in.)
centers, as shown in Figure 4.3 on page 6.
Instruction Manual
MON172CL20
Bosch Security Systems, Inc.
Advertisement
Table of Contents
