Backlighting And Contrast; Map Data Setup - Garmin eTrex Venture Owner's Manual And Reference Manual

Getting Started
Backlighting
and
Contrast
Press & Release POWER Button
to turn Backlighting On/Off
Use ZOOM IN & OUT Buttons
to Adjust Contrast
Map Data
Setup
4
Display Backlighting and Contrast Set Up
If lighting conditions make it hard for you to see
the display screen, you can adjust the contrast or turn on
the backlight.
To turn on the backlighting:
1. Press and release the POWER button to turn on
the backlight feature from any page on the unit. The
backlight will remain on until the set timeout period is
completed or the POWER button is pressed again.
The unit is factory set to timeout 15 seconds after
the last button press.
To adjust the screen contrast:
1. Use the ZOOM IN or OUT buttons to adjust the
contrast with the Satellite Page displayed.
Transferring MapSource "Points of Interest" Data
If you have purchased a GARMIN MapSource
of Interest" CD-ROM, you may want to load data for restau-
rants, shopping malls, lodging, attractions, entertainment,
transportation, etc. before beginning use. The eTrex Venture
will currently accept only the "Points of Interest" map data
guide.
Data transfer requires the use of a PC, a GARMIN
MapSource "Points of Interest" CD-ROM, and the PC Inter-
face Cable with RS232 serial port connector supplied with
this unit. Follow detailed instructions for data transfer in the
MapSource User' s Manual.
For detailed information concerning GARMIN MapSource
CD-ROM products contact yout GARMIN Dealer or use the
GARMIN website (www.garmin.com).
TM
"Points