Battery Installation; Backlighting And Contrast - Garmin eTrex Vista Owner's Manual And Reference Manual

Installing the Batteries
The eTrex Vista operates on two "AA" batteries (not
included), which are located in the back of the unit.
Rechargeable Alkaline, NiMH, NiCad or Lithium batteries
may also be used.
Stored data is not lost when
the batteries are removed.
To install batteries:
1. Remove the battery cover on
the back of the unit. Turn the
D-ring 1/4 turn counter-clock-
wise & pull away clockwise.
2. Insert batteries
observing the
polarity.
3. Reinstall the
battery cover
by turning the
D-ring 1/4
turn.
Display Backlighting and Contrast Set Up
If lighting conditions make it hard for you to see the
display screen, you can adjust the contrast or turn on the
backlight.
To turn on the backlighting:
1. Press the POWER button to turn on the backlight
from any page on the unit. The backlight remains
on until the set timeout period is completed or the
POWER button is pressed again.
The unit is factory set to timeout 15 seconds after
the last button press. (To reset the backlight time-
out, refer to page 51.)
To adjust the screen contrast:
1. When on the Satelllie Page, use the ZOOM IN or
OUT buttons to adjust the contrast.
Battery Compartment
D-ring
Battery Cover
Getting Started
Battery
Installation and
Backlight/Contrast
Important Note:
When replacing batteries, use
only new or fully recharged
batteries and do not mix
Alkaline, NiMH, NiCad or
Lithium batteries.
Rechargeable batteries may
typically display less capacity
than Alkaline batteries.
Remove the batteries from the
unit if you don't plan to use it
for several months.
Follow the battery manufactur-
er's instructions for proper care
and disposal of used batteries.
When using 'Battery Saver' or
'Use With GPS Off' mode when
not navigating, Alkaline batter-
ies can last up to 12 hours.
Press & Release POWER
Button to turn Backlighting
On/Off
Use ZOOM IN & OUT
Buttons to Adjust Contrast
3