Garmin eTrex Camo Quick Start Manual

eTrex Description
eTrex Description
1
Internal
GPS Antenna
UP
Button
PAGE
DOWN
Button
Button
POWER
ENTER/MARK
Button
Button
LCD Display
(with backlight)
External Power
and Waterproof Case
Data Connector
Battery
Compartment
eTrex Buttons
eTrex Buttons
2
The UP/DOWN Buttons:
• Select options on pages and menus
• Adjust Contrast on the SkyView Page
• Zoom in and out on the Map Page
• Cycle through trip computer data on
the Pointer Page
The ENTER Button:
• Confirms data entry or menu selections
• Displays Options on main pages
• Press and hold the ENTER
button to activate the Mark Waypoint
Page
The PAGE Button:
• Switches display pages
• Allows you to exit/quit a function
The POWER Button:
• Press and hold to turn the unit on/off.
• Press to turn the display backlight
on/off.
eTrex Setup
Installing the Batteries
3
The eTrex operates on two AA batteries (not included), which are
installed at the back of the unit. To install the batteries, remove the
battery cover by turning the D-ring at the back of the unit 1/4 turn
counter-clockwise. Insert the batteries into position observing proper
polarity. Attach the battery cover by turning the D-ring 1/4 turn
clockwise.
Battery Cover
D-ring
Selecting a Page
4
All of the information needed to operate the eTrex is found on five
main "pages" (or display screens). These pages are the SkyView, Map,
Pointer, Trip Computer, and Menu. Once power is applied, press the
PAGE button to switch between pages.
PAGE PAGE PAGE PAGE PAGE PAGE PAGE PAGE
SkyView
Map Pointer Trip Computer
eTrex Setup
Finding Your Current Position
5
Before you can actually use your eTrex for navigation, you must
first obtain a fix on your current position. To do this, take your
eTrex outside and find a large, open area that has a clear view of the
sky. Press and hold the POWER button to turn the unit on. You'll
see the Welcome Page for a few seconds while the eTrex performs a
self-test, followed by the SkyView Page. The eTrex needs to receive
at least three strong satellite signals to find your location.
When you see the "READY TO NAVIGATE" message on the
Satellite Page, eTrex has found your location.

NOTE: The first time you use your eTrex, it could take up
to five minutes to find your location. After the first time
use, eTrex only needs about 15 to 45 seconds to find
your location. If the eTrex does not display your local
time (bottom of the Menu Page), follow the instructions
in the Getting Started section of your Owner's Manual
to set the correct time.
SkyView
Welcome
Page
Page
Backlighting and Contrast
6
To turn the backlighting on, press and release the POWER
PAGE PAGE
button from any screen. The backlight is timed to stay on for 30
seconds to save battery power. To adjust the screen contrast, press
the PAGE button until you see the SkyView Page. Press the UP
Menu
button to make the screen darker, press the DOWN button to
make the screen lighter.
"Ready To
Navigate"