Install The Hood; Install The Blower; Connect Wiring (All Blowers) - Broan Elite E64000 SERIES Installation Instructions Manual

10. INSTALL THE HOOD

INTERNAL BLOWER: Run power cable to installation location. Place the hood in its location. Mark the position of the screws (smaller part
of the key holes [A]) with a pen. Remove the hood and install the (4) 1/2" double thread screws at marked positions, leaving a 1/8" gap.
Remove wiring cover. Insert the cable in the hood through the wire clamp and tighten the wire clamp to secure the cable. Place the hood
under the cabinet and slide it into position. Make sure the adapter (or the transition) enters the ducting. Secure the hood by tightening the
screws completely. Install the last 1/2" double thread screws in the remaining holes [B].
HD0265
EXTERIOR OR IN-LINE BLOWER: Run power cable to installation location. Place the hood in its location. Mark the position of the screws
(smaller part of the key holes [A]) with a pen. Remove the hood and install the (4) 1/2" double thread screws at marked positions, leaving a
1/8" gap. Remove wiring cover on top of the hood, punch-out the electrical knock-out and install the wire clamp. Insert the cable in the hood
through the wire clamp and tighten the wire clamp to secure the cable. Connect wiring (see instructions included with exterior or in-line
blower). Place the hood under the cabinet and slide it in position. Secure the hood by tightening the screws completely. Install the last 1/2"
double thread screws in the remaining holes [B].
11. CONNECT WIRING
Risk of electric shock. Electrical wiring must be done by qualified personnel in accordance with all applicable
codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting
means to prevent power to be switched on accidentally.
Remove wiring cover from rough-in plate or electrical compartment and set aside.
INTERNAL BLOWERS:
The ORANGE wire (A) is for make-up air device connection only.
If there is no make-up air device, never remove the cap on the
ORANGE wire end.
IN-LINE OR EXTERIOR BLOWERS: See instructions included with blower.

12. INSTALL THE BLOWER

Do not plug the 2 cords together.
Plug the 3-prong plug cord from rough-in plate to the 3-prong male connector inside
the hood (A) and the 2-prong male connector cord from rough-in plate to the 2-prong plug
inside the hood (B).
(ALL BLOWERS)
INTERNAL BLOWER HOOD
B
(ALL BLOWERS)
Connect cable into wiring box using wire connectors.
Connect BLACK to BLACK, WHITE to WHITE and GREEN
or bare wire under GREEN ground screw.
CAUTION
Reinstall wiring cover.
(EXTERIOR OR IN-LINE BLOWER)
WARNING
!
EXTERIOR OR IN
A
B
A
B
WARNING
!
11
-
LINE BLOWER HOOD
HE0088
B
HE0078
A
A