Features And Controls - Briggs & Stratton Troy-Bilt Operator's Manual

Features and Controls

Read this Operator's Manual and safety rules before operating your generator.
Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
A
B
C
D
E
F
G
H
A - Fuel Tank — Capacity of seven (7) U.S. gallons.
B - Rocker Switch Circuit Breaker — The 120/240 Volt AC,
30A locking receptacle is provided with a rocker switch
circuit breaker to protect the generator against electrical
overload.
C - 120 Volt AC, 20 Amp, Duplex Receptacles — May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool and motor loads.
D - Oil Fill Cap — Check and add engine oil here.
E - Oil Drain Plug — Drain engine oil here.
F - Circuit Breakers (AC) — The 120 Volt AC, 20A duplex
receptacles are provided with "push to reset" circuit
breakers to protect the generator against electrical
overload.
G - 120/240 Volt AC, 30 Amp Locking Receptacle — May
be used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
H - Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
10
J - Identification Label — Provides model, revision and
serial number of generator. Please have these readily
available when calling for assistance.
K - Spark Arrester Muffler — Exhaust muffler lowers engine
noise and is equipped with a spark arrester screen.
L - Air Cleaner — Protects engine by filtering dust and
debris out of intake air.
M - Choke Lever — Used when starting a cold engine.
N - Recoil Starter — Used to start the engine.
P - Engine Rocker Switch — Set this switch to "On" before
using recoil starter. Set switch to "Off" to switch off
engine.
R - Battery Float Charger Jack — Use battery float charger
to keep the starting battery charged and ready for use.
S - Start Button — Push and hold in start position for a
maximum of 15 seconds during each start attempt, until
engine starts.
T - Fuel Valve — Used to turn fuel supply on and off to
engine.
T
S
R
P
N
M
L
K
J
troybilt.com