Table 4-1 Wan/Lan - ZyXEL Communications ZyAIR B-4000 User Manual

LABEL
LAN
IP Address
Subnet Mask
WAN MAC Address
WAN Port Mode
DHCP Client
Static IP Settings
IP Address
Subnet Mask
Default IP Gateway
Primary/Secondary
DNS Server
PPPoE
Username
Password
PPP MTU Setting
TCP MSS Setting
Service Name
Connect on Demand
WAN, LAN and Server Setup

Table 4-1 WAN/LAN

Enter the LAN IP address of the ZyAIR in dotted decimal notation. The default is
192.168.1.1.
Enter the LAN subnet mask in dotted decimal notation. The default is
255.255.255.0.
Select Default to use the factory assigned MAC address.
If your ISP requires MAC address authentication, select Change to and enter the
MAC address of a computer on the LAN in the fields provided.
Select this option to set the ZyAIR to act as a DHCP client on the WAN. The
ZyAIR obtains TCP/IP information (IP address, DNS server information, etc.)
from a DHCP server. This is the default setting.
Select this option to set the ZyAIR to use a static (or fixed) IP address.
Enter the static IP address in dotted decimal notation.
Enter the subnet mask in dotted decimal notation.
Enter the IP address of the default gateway device.
Enter the IP addresses of the primary and/or secondary DNS servers.
Select this option to activate PPPoE support. Refer to Section 4.6 for more
information.
Enter the user name exactly as your ISP assigned. If assigned a name in the
form user@domain where domain identifies a service name, then enter both
components exactly as given.
Enter the password associated with the user name above.
Enter the MTU (Maximum Transfer Unit) size.
Enter the MSS (Maximum Segment Size) size.
Enter the name of your PPPoE service.
Select this option when you don't want the connection up all the time and specify
an idle timeout in the Max Idle Time field. This is the default setting with an idle
timeout of 10 minutes.
ZyAIR B-4000 Hot Spot Gateway
DESCRIPTION
4-5