Touch Sensor Tone; Switching Preout; Digital Crossover Network; External Amp Control - Kenwood DPX-6020 Instruction Manual

Function set system
Function items in Standby mode:

1. Touch Sensor Tone

This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting
"BEEP On"
"BEEP Off"

2. Switching Preout

Switch the preout between the rear and non-fading. When you
switch to non-fading, you can adjust the volume separately.
The factory default is rear preout.
Display and setting
"Preout Rear": Rear preout
"Preout N-F": Non-fading preout
NOTE
• Be sure to turn the power of this unit off and on after you
switch the preout.
• When this function is set to "Preout N-F", functions 4, 5 and 8 in
the section "Function items in Other mode:" are available.

3. Digital Crossover Network

If this function is set to on, you can adjust the setting of the
Crossover network.
Display and setting
"D.X 'over On"
"D.X 'over Off"
NOTE
When this function is set to on, functions from 1 to 8 in the
section "Function items in Other mode:"(see p32) are available to
be controlled.

4. External Amp Control

If this function is set to on, you can control the external
amplifier.
Display and setting
"Amp Cont On"
"Amp Cont Off"
NOTE
When this function is set to on, the External Amp Control Setting
function (function 9) in the section "Function items in Other
mode:" is available to be controlled.

5. Opening Display

If this function is set to on, the opening display appears when
the power is turned on.
Display and setting:
"Opening On": Opening display function is on.
"Opening Off": Opening display function is off.
— 30 —