Table of Contents
Advertisement
8. After the customer enters registration information, write the
information in Figure 20 on the cover of their User Guide.
9. Select
in the Registration screen in Figure 20. The
Continue
Antenna Pointing - Antenna Location
Figure 21.
Figure 21: Enter ZIP code
10. Verify that the ZIP code shown matches the ZIP code for the
installation site. If not, correct it. Select Next. The
Pointing - Receiver
point it shows no signal strength or auto cross-pol checkbox.
11. Click through all pointing screens by selecting Next. Click
through until you reach the
will finish registration before peaking the signal.
Note: You must not disconnect the power cables before
completing Step 13. Finish registration before peaking the signal.
12. When the
Websetup-Finish
receives a parameter file from the WebACS and transfers it to
the DW4020 over the Ethernet connection. If it is successful,
a message appears asking you to press Finish. See Figure 23.
13. Select Finish. The unit is commissioned. A message may
appear telling you to connect and reconnect the USB cable.
Click OK. You do not need to do anything with the USB
cable at this time.
Chapter 2 • Installing the indoor equipment
screen appears. See
screen appears. See Figure 22. At this
Websetup - Finish
screen appears, Websetup
1031484-0001 Revision 2
Antenna
screen. You
25
Advertisement
Table of Contents
