Table of Contents
Advertisement
5
2
1
If set to Radio (in Step 4), then
while the frequency is blinking,
set the frequency using the Tune/
Skip/Search Down o 1 or Up n
2 button.
NOTE: When the alarm time is
reached, the unit will turn on the
frequency that you selected.
NOTES:
•
When the actual time matches the selected preset alarm time, if set to Buzzer
or Radio, the unit will automatically turn on for 59 minutes and then shut off. If
set to iPod, the unit will start playback on the track that you selected and the
tracks following it in the playlist. (See Step 6 above.)
•
When the alarm time is reached, the alarm volume level will be set to the
minimum (Level 0) and it will increase one level continuously until the desired
maximum volume level (see Step 3 on the previous page) is reached.
•
While the alarm is on, if you press any button on the unit (except the
SNOOZE/DIMMER button or the Power button), the unit will change from
Alarm mode to normal Power On mode, so you can adjust any setting (i.e.,
volume level, radio frequency, etc.) as desired.
•
TO SHUT OFF THE ALARM, see TO SHUT THE ALARM OFF section on
the next page.
OPERATION (CONTINUED)
6
If set to iPod (in Step 4), insert the
iPod as shown on page 8. Select your
desired track and then make sure
both your iPod and this unit are turned
off. When the alarm time is reached,
this unit will start playback on the
track that you selected and the tracks
following it in the playlist. This unit
will playback for 59 minutes then turn
off automatically or, if the remaining
playlist has less than 59 minutes of
playback time remaining, this unit will
just playback the remaining time of
the playlist and then stop.
14
Hide quick links:
Advertisement
Table of Contents
