Bosch GAS Professional 14,4 V-LI Instructions Manual page 7

OBJ_BUCH-1819-001.book Page 7 Thursday, February 28, 2013 10:57 AM
Product Description and Specifica-
tions
Intended Use
The vacuum cleaner is intended for vacuuming and extracting
materials that are not hazardous to one's health. The vaccuum
cleaner is intended for commercial use, for example in hotels,
schools, factories, shops, offices and rental businesses.
Use the vacuum cleaner only when you fully understand and
can perform all functions without limitation, or have received
appropriate instructions.
Product Features
The numbering of the product features refers to the illustra-
tion of the vacuum cleaner on the graphics page.
1 Release button for dust cup
2 LED
3 Vacuum power button "High/Low"
Technical Data
Cordless dry vacuum cleaner
Article number
Container volume (gross)
Vacuum, max.
Airflow, max.
Weight according to EPTA-Procedure 01/2003*
Battery
Rated voltage
Operating duration per battery-pack charge
– Vacuuming power "High"
– Vacuuming power "Low"
* dependent of the battery pack being used
Assembly
Battery Charging
 Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the lith-
ium ion battery pack used in your vacuum cleaner.
Note: The battery is supplied partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
does not damage the battery.
The Lithium-Ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
 After the automatic shut-off of the vacuum cleaner, do
not continue to press the On/Off button. The battery
pack could become damaged.
Bosch Power Tools
4 On/Off button
5 Suspension strap
6 Battery pack
7 Motor housing
8 Dust cup
9 Extension tube
10 Crevice nozzle
11 Holder for crevice nozzle
12 Floor nozzle
13 Battery unlocking button
14 Filter assembly
15 Filter cover
16 Filter seal
17 HEPA filter
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.
GAS 14.4 V-LI
3 601 JC6 050
l
kPa
l/s
kg 1.5/1.3
Li-Ion
V=
min/Ah
min/Ah
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range of be-
tween 0 °C and 45 °C. A long battery service life is achieved
in this manner.
Observe the notes for disposal.
Removing the battery (see figures A1 – A2)
The battery 6 is equipped with two locking levels that should
prevent the battery from falling out when pushing the battery
unlocking button 13 unintentionally. As long as the battery is
inserted in the power tool, it is held in position by means of a
spring.
– To remove the battery pack 6, press the battery unlocking
button 13 and pull the battery pack toward the rear out of
the vacuum cleaner. Do not exert any force when doing
this.
English | 7
GAS 18 V-LI
3 601 JC6 150
3 601 JC6 180
0.7 0.7
3.7 4
18.7 19.3
1.6/1.4
Li-Ion
14.4 18
8 9
20 20
1 609 92A 04G | (28.2.13)