Table of Contents
Advertisement
Remote Control Function
<Provided with the KTC-V800N/KTC-V800P>
2CAUTION
Do not set the remote on hot places such as above the
dashboard.
Loading and Replacing the Batteries
1. Use two "AA" batteries:
Slide the cover while pressing downwards to remove it
as illustrated.
2. Insert the batteries with the ª and · poles aligned
properly following the illustration inside the case.
2WARNING
Store unused batteries out of the reach of children. Contact
a doctor immediately if the battery is accidentally swallowed.
NOTE
•The provided batteries are intended for use in operation checking, and their service life may
be short.
• When the remote controllable distance becomes short, replace both of the batteries with
new ones.
MODE
V.SEL
BAND
4
¢
SEARCH
CH. –
CH. +
M/S
5
SEEK
AV OUT
VOL
∞
AME
SP
REMOTE CONTROL UNIT
RC-210
Monitor Control Function
• V.SEL button
Each time you press V.SEL button to switch the monitor's picture.
• MODE button
Each time you press MODE button to switch the screen mode.
• AV OUT button
Each time you press AV OUT button to switch the AV output
mode.
TV Control Function
• BAND button
Each time you press the BAND button, the preset band
switches between the TV1 and TV2.
• SEARCH buttons
Press the ¢/CH.+ button to make increasing seeks.
Press the 4/CH.– button to make decreasing seeks.
• SEEK button
Each time you press the SEEK button, the seek mode switches
to auto 1, to auto 2 and to manual.
• AME button
You can automatically store all the receivable channels in the
band currently being looked to.
1
Select the band for auto memory entry.
2
Press the AME button.
3
Press the ¢/CH.+ button to start auto memory entry.
9
Advertisement
Table of Contents
