Playing Cassette Tapes; Fast Forwarding And Rewinding Cassette Tapes; Using Dolby B/C Noise Reduction - Kenwood KRC-PS979R Instruction Manual

Playing Cassette Tapes

Loading and Playing Cassettes:
Press the 0(EJECT) button to slide open the faceplate,
showing the cassette (insertion) slot. Holding the cassette with
the tape exposed to the right, insert it in the slot.
The faceplate will close, and the tape will start playing.
The IN indicator lights up when a cassette has been loaded.
Playing Cassettes Already Loaded:
Press the SRC button repeatedly until the tape mode is
obtained. "TAPE" is displayed when the tape mode has been
selected.
The tape will start playing.
Listening to the other side:
Press the PROG button.
Tape play switches to the other side.
Eject:
Press the 0(EJECT) button to stop tape play. The faceplate will
slide to eject the tape.
Press the 0(EJECT) button to close the faceplate.
2CAUTION
When the faceplate has been slid open, it might interfere with
the gear lever or something else. If this happens, pay attention to
safety and move the gear lever or take an appropriate action,
then operate the unit.
NOTE
• The sound will be temporarily muted whilst the faceplate is
moving.
• Remove a cassette from the unit when not listening to it for a
whilst. If you leave it in the unit too long, the tape may stick to
the tape head and cause the unit to malfunction.

Fast Forwarding and Rewinding Cassette Tapes

Fast Forwarding Tapes:
Press the FM button.
Rewinding Tapes:
Press the AM button.
Cancelling:
Press the PROG button.
Normal tape play returns.

Using Dolby B/C Noise Reduction

Listen to tapes recorded using the Dolby B or C NR system.
Turning Dolby NR On/Off:
Press the B-C NR button repeatedly to switch the Dolby NR
selection as follows.
Dolby B NR ON
Dolby C NR ON
Dolby NR OFF
The B NR indicator lights up when Dolby B NR is turned on,
and the C NR indicator when Dolby C NR is turned on.
— 25 —