General Operation; Audio Control; Audio Setup; Speaker Setting - Kenwood KMR-330 Instruction Manual

General Operation

Audio Control

You can adjust following Audio Control items;
Adjustment Item Display
Subwoofer level "SUB-W L"
Bass Boost "B.BOOST-L"
System Q "NATURAL"/
"USER"/"ROCK"/
"POPS"/"EASY"/
"TOP40"/"JAZZ"
Bass level "BASS L"
Middle level "MID L"
Treble level "TRE L"
Balance "BALANCE"
Fader "FADER"
Exit Audio Control mode (Volume control mode)
⁄
• "USER": The customized Bass, Middle, and Treble levels
are effective. This item is displayed only when the tone
quality has been adjusted.
This item disappears when another setting is selected.
• You can set Bass, Middle, and Treble for each source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the Control knob.
3
Select the Audio item to adjust
Press the Control knob.
4
Adjust the Audio item
Turn the Control knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the Control knob or 0
button.
6
|
KMR-330
Range
–15 — +15
"L1"/"L2"/"OFF"
(The indicator turns on
according to the setting.)
Natural/User setting/Rock/
Pops/Easy/Top 40/Jazz
(The indicator turns on
according to the setting.)
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15

Audio Setup

You can set Sound system, such as follows;
Adjustment Item Display
Low Pass Filter "LPF SW"
Volume offset "V-OFFSET"
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the Control knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the Control knob.
4
Adjust the Audio setup item
Turn the Control knob.
5
Exit Audio Setup mode
Press the Control knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the Control knob.
3
Select the Speaker type
Turn the Control knob.
4
Exit Speaker Setting mode
Press the Control knob.
Range
80/120/160/Through Hz
–8 — ±0 (AUX: -8— +8)
Display
"SP SEL OFF"
"SP SEL 5/4"
"SP SEL 6*9/6"
"SP SEL OEM"