General Operation; Audio Control; Audio Setup; Speaker Setting - Kenwood KMR-330 Instruction Manual

General Operation
Audio Control Audio Setup
You can adjust following Audio Control items;
You can set Sound system, such as follows;
Bass level "BASS L" -8 - +8
Fader "FADER" Rear 15 - Front 15
Middle level "MID L" -8 - +8
AdlBlllliUIlI_w~III'IIICdlllll
Low Pass Filter "LPF SW" 80/120/160/Through Hz
Volume offset "V-OFFSET" -8 - ±O (AUX: -8- +8)
~
~
• Volume offset: Sets each source's volume as a difference
from the basic volume.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the Control knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the Control knob.
4
Adjust the Audio setup item
Turn the Control knob.
S
Exit Audio Setup mode
Press the Control knob for at least 1 second.
-15-+15
"L1" I'll" I"OFF"
(The indicator turns on
according to the setting.)
"NATURAL" / Natural/User setting/Rock/
"USER"I"ROCK"/ Pops/Easy/Top 40/Jazz
"POPS"I"EASY"/ (The indicator turns on
"TOP40"!"JAZZ" according to the setting.)
"SUB-W L"
"B.BOOST-L"
System
Q
Subwoofer level
Bass Boost
• "USER": The customized Bass, Middle, and Treble levels
are effective. This item is displayed only when the tone
quality has been adjusted.
This item disappears when another setting is selected.
• You can set Bass, Middle, and Treble for each source.
Balance "BALANCE" Left 15 - Right 15
Exit Audio Control mode (Volume control mode)
Q
~
Treble level "TRE L" -8 - +8
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the Control knob.
3
Select the Audio item to adjust
Press the Control knob.
4
Adjust the Audio item
Turn the Control knob.
S
Exit Audio Control mode
Press any button.
Press a button other than the Control knob or
~
button.
Speaker Setting
Fine-tuning so that the System
Q
value is optimal
when setting the speaker type as follows;
"SP SEL OFF"
"SP SEL 5/4"
"SP SEL 6*9/6"
"SP SEL OEM"
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the Control knob.
3
Select the Speaker type
Turn the Control knob.
4
Exit Speaker Setting mode
Press the Control knob.
6
I
KMR-330