Section 5 - Handlebars & Controls; Handle Bars; Controls - Ariens snow-thro 924124-128 Service Manual

5.1 HANDLE BARS

The handle bars are held in place to the lower handle
bars with four bolts and wing knobs.(Figure 18) For
service put the unit in service position up on the auger
housing.
To service:
1. Check all fasteners
2. All levers and pivot points should operate freely
3. All bushings and guide holes should not be
excessively sloppy
3
3
2
1
1. Wing Knob
2. Attachment Clutch Lever
3. Spring Clip
4. Traction Drive Clutch
Figure 18
SECTION 5 - HANDLEBARS & CONTROLS
4
3
3

5.2 CONTROLS

Check Function of Dual Handle Interlock
Without the engine running, press down (engage) both
clutch levers Figure 18. Release attachment clutch
lever. Attachment clutch should remain engaged until
traction clutch lever is released, then both clutches
must disengage. If they do not, contact your dealer for
repairs.
The controls operate a rod or a cable.
The functions are:
Remote Chute Deflector
Auger
Traction
Speed
All of the movement and pivot points must operate
freely.
To service:
1. Check all fasteners.
2. All bushings and guide holes should not be
excessively sloppy.
3. Cables and springs should be clean.
PS0814
5 - 23