Ariens snow-thro 924124-128 Service Manual page 18

8. Remove attachment drive belt from attachment
pulley (hold brake away from belt).
Install new attachment drive belt:
1. Place new attachment belt onto attachment pulley.
2. Tip housing and frame back together and secure
with cap screws.
3. Place belt onto engine sheave.
4. Make sure engine sheave and attachment pulley
align. If alignment is necessary, loosen attachment
pulley set screws, reposition pulley and retighten
set screws.
5. Reposition and secure belt fingers.
IMPORTANT: Make sure belt fingers are 1/16 in. to 1/8
in. (1.6-3mm) from belt when attachment clutch is
engaged.
6. Check adjustment. See Attachment Clutch/Brake.
WARNING: AUGER / IMPELLER MUST
STOP within 5 seconds when attachment
clutch lever is released or unit damage or
serious injury may result.
4 - 18