Spectrum Analyzer Display Selection; Automatic Dimmer Function; Demonstration Function; Input Sensitivity Adjustment - Kenwood KGC-9044 Instruction Manual

Spectrum Analyzer Display Selection

You can select the display to enjoy sounds with eyes.
Switching the Spectrum Analyzer Display:
Each time you press the S.A button, the spectrum analyzer
display switches as follows;
1 "SCAN MODE ON":Displays 2 to 9 are automatically
shown in succession for about five seconds each.
2 "PEAK HOLD"
3 "LASER"
4 "H-SCOPE"
5 "FIREWORKS"
6 "SQUASH"
7 "V-SCOPE"
8 "BLIZZERD"
9 "KISS"
0 "SIDE WAVE"
! "EQ CURVE":Equalizer curve
@ "SPEANA OFF":Spectrum analyer off

Automatic Dimmer Function

The display dims when the car's lights are turned on.
NOTE
The dimmer function is not available for units if the dimmer
cable is not connected.

Demonstration Function

You can give a demonstration of the spectrum analyzer and
the equlizer curves to know what displays this unit has.The
DEMO indicator lights up when the demonstration function is
on.
Starting Demonstration:
Pressing the S.A button for more than one second will turn on
demonstration mode.
Cancelling Demonstration:
Press the S.A button.

Input Sensitivity Adjustment

Adjust this control according to the pre-out level of the centre
unit connected to this unit.
1
Removing the faceplate (see page 8)
2
Adjusting the input sensitivity volume.
Input sensitivity
decreased.
M A X
M IN
3
Reattaching the faceplate (see page 8)
NOTE
Refer to "Specifications" on the centre unit's
instruction manual about the pre-out level.
If the input sensitivity is not adjusted
correctly, sound distortion may occur.
— 7 —
Input sensitivity
increased.
(2V)
MIN MAX
(4V) (1V)
(Value of input
sensitivity)