Other Operations Menu System - Kenwood KGC-9044 Instruction Manual

Other operations
Menu System
To accommodate a greater number of functions, a function set
system has been employed for making settings. Press the
MENU button to enter the function set mode and then display
the function to make the setting.
1
Press the MENU button to enter the function set mode,and
the MENU indicator lights.
2
Press the 2 or 3 button.
Each time the button is pressed, the adjustment mode will
change as follows:
∞
"MENU FADER" (Fader)
∞5
"MENU HPF-F" (High-pass filter for front output)
∞5
"MENU HPF-R" (High-pass filter for rear output)
∞5
"MENU LPF-S" (Low-pass filter for subwoofer output)
∞5
"MENU SUBW LV" (Subwoofer preout level)
∞5
"MENU ANA LV" (Analizer level)*
∞5
"MENU LCD CNT" (LCD contrast level)*
∞5
"MENU PREOUT" (Rear / Front output boost)*
5
3
Press the u or d button.
Look at the table to adjust the mode being displayed.
4
Press the MENU button to end the function set mode.
*1: It varies according to the volume setting on the centre unit, so set
the volume level to normal on the centre unit before adjusting it.
*2: The contrast on the equaliser/spectrum analyser display is not
adjustable.
*3: If the sensitivity of the connected amp is high enough to
accommodate 4V, set the boost level to "HIGH". Otherwise, set it to
"LOW".If it has been set to "HIGH", set the input sensitivity on the
amp side to 4V. If it is set lower than 4V, noise may be output.
NOTE
The menu settings cannot be stored in the user memory.
1
2
3
— 6 —
Table of Adjustment Mode
Adjustment
Operation of Control button
mode
u button
(Display)
Fader Front channel
("FADER") emphasized.(F15)
You can select the frequency to be cut, as
High-pass
follows:
filter for front
OFF (through)
output
100Hz 120Hz
("HPF-F")
You can select the frequency to be cut, as
High-pass
follows:
filter for rear
OFF (through)
output
100Hz 120Hz
("HPF-R")
Low-pass
You can select the frequency to be cut, as
filter for
follows:
subwoofer
50Hz 80Hz
output
("LPF-S")
Subwoofer
The subwoofer
Preout Level
sound is increased.
("SUBW-LV")
Analizer The spectrum
level* 1 analyzer level
("ANA LV") increased.
LCD contrast
The setting values
level* 2
higher.
("LCD CNT")
Rear / Front
output boost* 3
Boost on.("HIGH")
("PREOUT")
d button
Rear channel
emphasized.(R15)
40Hz 60Hz 80Hz
150Hz 180Hz 220Hz
40Hz 60Hz 80Hz
150Hz 180Hz 220Hz
120Hz OFF (through)
The subwoofer sound
is decreased.
The spectrum analyzer
level decreased.
The setting values
lower.
Boost off.("LOW")