Positioning The Washing Machine; Adjusting The Feet; Connecting To Water Supply - Whirlpool PROW 0612IIM Installation And Maintenance Manual

POSITIONING THE WASHING MACHINE

The washing machine can be built-in or free-
standing. It should be positioned so that there
is an electrical socket within easy reach.
A. Built-in
The washing machine can be built in under a
worktop with a working height of 850–900 mm.
Leave a 5 mm gap around the machine. This
also applies between the rear edge of the top
the machine and the wall behind.
B. Free-standing
The washing machine can be placed alongside
or underneath the tumble dryer.
MECHANICAL INSTALLATION
The machine can be anchored to the floor, see
enclosed bag containing instructions and parts.

ADJUSTING THE FEET

Adjust the feet so that the machine is level and
steady on the floor.
Tighten the lock-
ing nuts.
Locking nut

CONNECTING TO WATER SUPPLY

The machine should be connected to the water
supply by someone who has the necessary skill.
The machine is connected using the supplied
inlet hose.
NOTE!
It is important that you use the inlet hose that
is supplied, not an old hose.
The water pressure must be 0.1–1 MPa
2
(about 1–10 kp/cm ; 10–100 N/cm
The water supply pipe must be fitted with a
shut-off valve.
If the supply pipe has just been installed we
recommend that it is flushed out thoroughly
2
).
WASHING MACHINE
9