Cleaning The Lint Filter; In Areas With Hard Water - Whirlpool PROW 0612IIM Installation And Maintenance Manual

CLEANING THE LINT FILTER HOLDER
Dust and dirt can gather in the bottom of the
lint filter holder. Take out the lint filter and use
a vacuum cleaner to clean the filter holder.
1. Grasp the filter handle
and pull it towards
you.
2. Slide the filter out
of the filter holder.
3. Open the filter and
rub off any lint with
your hand. Rinse out
the filter to
remove
any li-
mescale
deposit.
4. Fold
the filter
and put it
back in the filter holder.
MAINTENANCE
Clean the outside of the machine
Clean the fan
Clean the condenser
Clean the lint filter and lint filter holder
Maintenance chart for tumble dryer.
TUMBLE DRYER
34

IN AREAS WITH HARD WATER

If the machine is installed in an area that has
hard water this can produce a limescale deposit
on the lint filter.
When you clean the lint filter check if there
is any limescale deposit. If there is, wash out the
lint filter by hand.
EMPTYING THE CONDENSATION WATER TANK
(only applies to condenser tumble dryer, when
drain hose isn't used)
Empty the condensation water
tank after each tumble
drying.
Pull out
the conden-
sation water
tank, empty
the water and put the tank back.
If the tank becomes too full the program will
be interrupted. Empty the tank and press the
-button and the program will continue
from where it was interrupted.
MAINTENANCE INTERVAL
As necessary or when cleaning
the laundry room.
At least once a year or each 300 cycle
Approx. 6 times a year or each 50 cycle
After each tumble drying
MAINTENANCE