Electrical Installation; Connecting To Coin Mechanism - Whirlpool PROW 0612IIM Installation And Maintenance Manual

ELECTRICAL INSTALLATION

ELECTRICAL INSTALLATION
The washing machine must be connected using
a permanently installed cable through an isola-
ting switch by a qualified electrician.
Power supply
The machine is supplied as single-phase, 230 V,
50 Hz, heat output 2500W and has 13 A.
If an earth leakage circuit breaker is fitted it
must be of type A.
Reconfiguration
The machine can be reconfigured The machi-
ne should be reconfigured as shown in the wi-
ring diagram underneath the top panel of the
machine.
NOTE!
Electrical connection /reconfiguring must be
carried out by a qualified electrician.
TUMBLE DRYER
30
Connecting the tumble dryer and Whirlpool
washing machine together
Wiring the two machines together as described
below must be carried out by a qualified elec-
trician.
To ensure a uniform load on the phases when
installing a 3-phase tumble dryer together with
an Whirlpool washing machine for single-phase
operation the phases should be connected as
follows:
Tumble dryer:
Terminal marked L1 to phase 1.
Terminal marked L2 to phase 2.
Terminal marked L3 to phase 2.
Washing machine:
Terminal marked L to phase 3.
CONNECTING TO A COIN MECHANISM
Connection to a coin mechanism must be car-
ried out by a qualified electrician.
The coin mechanism must be connected bet-
ween the tumble dryer's power lead and the
wall socket.
ELECTRICAL INSTALLATION