JVC InteriArt LT-26C31BC Service Manual page 11

3.1.3 REMOVING THE FAN BRACKET, REGULATOR PWB AND POWER CORD (Fig.3-1-3)
• Remove the STAND ASS'Y.
• Remove the REAR COVER.
(1) Disconnect the wire(CONN. [Y]) of COOLING FAN.
(2) Remove the 5 screws [F], and remove the FAN BRACKET.
(3) Remove the REGULATOR PWB, and disconnect the
POWER CORD.
(4) Remove the 1 screw [G], and remove the POWER CORD
HOLDER.
3.1.4 REMOVING THE RECEIVER PWB (Fig.3-1-4)
• Remove the STAND ASS'Y.
• Remove the REAR COVER.
(1) Remove the 2 screws [H] and 2 screws [J], then remove the
TERMINAL BASE.
(2) Remove the 5 screws [K], and remove the RECEIVER
PWB.
3.1.5 REMOVING THE FRONT CONTROL PWB AND FRONT SENSOR PWB (Fig.3-1-5)
• Remove the STAND ASS'Y.
• Remove the REAR COVER.
(1) Remove the 2 screws [L], and remove the CONTROL
KNOB.
(2) Remove the 3 screws [N], then remove the FRONT
CONTROL PWB and FRONT SENSOR PWB.
F
COOLING FAN
REGULATOR
PWB
G
G
Fig.3-1-3
TERMINAL BASE
K
RECEIVER PWB
H
J
Fig.3-1-4
M
FRONT CONTROL PWB
EARTH PLATE
L
FRONT SENSOR PWB
T
U
CONTROL KNOB
CLAMP
HARNES( F,U,T),"S" WIRE
F
Fig.3-1-5
FAN BRACKET
F
POWER CORD
G
POWER CORD HOLDER
K
T
(No.YA169)1-11