Desa A Series Owner's Operation And Installation Manual page 8

DESA INTERNATIONAL
UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
ASSEMBLING AND
ATTACHING OPTIONAL
BRASS TRIM
(Included with Mantel
Accessory)
IMPORTANT: If you are recessing the fire-
box in a wall, do not attach brass trim at this
time. See page 13.
Note: The instructions below show assem-
bling and attaching brass trim to fireplace.
1. Remove packaging from three pieces
of brass trim.
2. Locate four brass screws, two adjust-
ing plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as
shown in Figure 6.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top brass trim
(see Figure 6).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side brass
trim (see Figure 6).
6. While firmly holding edges of brass
trim together, tighten both set screws
on the adjusting plate with slotted
screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x
6.25 shoulder) into holes in cabinets.
Place the assembled trim onto fireplace
cabinet. Align hanging notches on trim
with hanging screws on side of fire-
place (see Figure 7). Push trim firmly
into place, sliding hanging notches over
hanging screws.
Set Screws
Side Brass
Trim
Adjusting
Plate
Shim
Mitered Edge
Slot
Figure 6 - Assembling Brass Trim
Assembled
Brass Trim
Figure 7 - Attaching Brass Trim to
Fireplace
INSTALLING OPTIONAL
BLOWER ACCESSORY (FOR
MODEL VSGF28PVA)
The following instructions are for optional
blower accessories GA3700 and GA3700T.
If you do not have this accessory and wish to
purchase one, see Accessories on pages 26
and 27 of this manual.
Installing Optional GA3700
Blower Accessory
1. Remove screws that attach log base as-
sembly to fireplace. Carefully lift up log
base assembly and remove from fire-
place, taking care to pull flexible gas line
through the access holes (see Figure 8).
CAUTION: Do not pick up log
base assembly by burners. This
could damage burners. Only
handle base by grates.
2. Place the blower against lower rear wall
of firebox outer wrapper with the ex-
haust port directed upward. Align the
holes in top mounting tabs of blower
Top
with holes in wall of wrapper (see Fig-
Brass
ure 9). Using 2 screws provided, mount
Trim
blower and tighten screws securely.
3. Be certain that all wire terminals are
securely attached to terminals on
blower motor and that the screw retain-
ing the green ground wire is tight.
4. Place control knob provided on plastic
control shaft of speed control.
Slot
5. Mount the speed control on the front
leg of the left floor support bracket us-
ing 2 screws provided (see Figure 10).
Trim
Hanging
Screws
Hanging
Notches
on Trim
Figure 8 - Removing Log Base from
Fireplace
Figure 9 - Mounting Blower to Firebox
Screws
Control
Knob
Figure 10 - Attaching Speed Control to
Firebox
8
Flexible
Gas Line
Screws
Log Base
Lower
Rear Wall
of Firebox
Exhaust
Post
Screws
Blower
Left Floor
Support
Bracket
Speed
Control
Control
Shaft
104410