Sony HT-ST7 Operating Instructions Manual page 17

Adjusting the settings / Configuration des r glages
MENU
,I,/41,
ENTER
RETURN
Press MENU on the remote control then select the desired setting using {/_/ENTER/RETURN.
Menu Function Default
You can enjoy Dolby Digital sound at low sound volumes. (ON/AUTO/OFF)
DRC
LEVEL (DYNAMIC RANGE ON: Compresses sound in accordance with the compression information AUTO
contained in the content.
CONTROL) AUTO: Automatically compresses sound encoded in Dolby TrueHD.
SYNC You can adjust the sound when the image and the sound are not in sync.(1 - 4/
(AV SYNC) OFF) OFF
DUAL You can enjoy multiplex broadcast sound of Dolby Digital audio. (M/S (main and
(DUAL MONO) sub channels)/MAIN (main channel)/SUB (sub channel)) MAIN
S. OPT Adjusts the sound so that it is reproduced dynamically and more clearly even at
(SOUND OPTIMIZER) low sound volumes. (ON/OFF) OFF
AUDIO Reproduces the very low volume sounds that tend to be eliminated by audio
HEQ compression. (ON/OFF) ON
(HARMONICS EQUALIZER) Note: HEQ functions only when "BT AU" is selected. This does not function with
any other inputs, even though the item is displayed on the front panel.
AAV
(ADVANCED AUTO Reduces the volume discrepancies between different programs or between OFF
VOLUME) programs and commercials. (ON/OFF)
CTRL
Switches the Control for HDMI function on or off. (ON/OFF) ON
(CONTROL FOR HDMI)
HDMI
P.THRU
(PASSTHROUGH)
ARC
(AUDIO RETURN
CHANNEL)
BT.STBY
(BLUETOOTH STANDBY)
AUTO
Sets the power saving mode of the pass-through function of HDMI signals.
(AUTO/ON)
AUTO: Outputs signals from the HDMI OUT TV (ARC)jack of the system in
standby mode when the TV is turned on. This setting saves power in
standby mode compared with the "ON" setting.
ON: Always outputs signals from the HDMI OUT TV (ARC)jack in standby mode.
Note: This item appears only when "CTRL (CONTROL FOR HDMI)" is set to "ON."
Allows you to listen to digital sound from a TV compatible with the Audio Return
Channel (ARC) technology is connected using an HDMI cable. (ON/OFF)
Note: This item appears only when "CTRL (CONTROL FOR HDMI)" is set to "ON."
When the system has pairing information, the system is in BLUETOOTH standby
mode even when it is turned off. (ON/OFF)
Note: During BLUETOOTH standby mode, the BLUETOOTH indicator flashes in
blue slowly.
Sets whether or not the system will use AAC via BLUETOOTH. (ON/OFF)
Note: If you change the setting when the system is connected with a
BLUETOOTH device, the system will be disconnected from the device.
ON
OFF
SET BT
AAC
(ADVANCED AUDIO OFF
CODING)
17