Reebok i-Trainer.SE User Manual page 6

Assembly
Reebok i-Trainer.SE
Handles
11. Remove the nut, bolt and washers pre assembled into the front of the pedal arm (fig.1).
12. Connect the handle to the front of the pedal arm using these components,
as illustrated (fig.2).
13. Cover the end of the handlebar by fitting the handlebar cover inners (216 & 217) to the
handlebar cover outers (712 & 713) as shown and secure using 4 x 802 screws (fig.3).
14. Repeat this process for the other handlebar.
You will require:
6mm
Front Rear
802
712
216
3
RFE 4489_RE014201_iTrainerSE_UMFINAL.indd 8-9
Customer Support 0800 440 2459
802 x 8 712 x 2 216 x 2 217 x 2 713 x 2
2
1
217
802
713
08
Reebok i-Trainer.SE
Upper Handlebars and Covers
15. Push the tops of the upper handlebars (213 & 260) into the handlebar tubes (fig.1)
16. Fix these using 4 x 290 bolts and 4 x 814 curve washers into each handlebar.
17. Once both handlebars are secure, place the handlebar covers (205 & 237)
over the joint, and fix using 2 x 802 screws into each handlebar.
You will require:
814 x 8
5mm
213 x 1
260 x 1
1
reebokfitness.info
290 x 8 802 x 4 205 x 2 237 x 2
260
814
237
205
802
09
213
802
290
25/06/2010 16:09