Kenwood KDC-719 Instruction Manual page 35

Installation
W Removing the hard rubber frame
W Removing the Unit
-
1
Engage the catch p@s on the removal tool and remove the two
locks on the lower level.
1
Refer to the section "Removing the hard rubber frame" and then
remove the hard rubber frame.
2 Remove the screw (M4 x 8) on the back panel.
3 Insert the two removal tools deeply Into the slots on each side,
as shown.
Lower the frame and pull It forward as shown In the figure.
Removal tool
2 When the lower level IS removed, remove the upper two
locations.
/
@
The frame can be removed from the top srde rn the same manner
(commercrally '
available)
Screw iM4X8)
4 Lower the removal tool
toward the bottom, and pull
out the unrt halfway while
pressrng towards the inside.
A
Be careful to avoid rnrury from
the catch pins on the removal
tooi
5 Pull the unit all the way out
with your hands, being
careful not to drop it.
- 35 -