Kenwood KDC-719 Instruction Manual page 34

n Installation
Flrew~lll or metal support
Screw (M4X8)
(commercially
ava;lable)
Bend the tabs of the
mounting sleeve
with a screwdriver or
/
\
similar utensil and
/
\
attach It I" place.
Self-tapping screw
Metal mounting strap
(commercially available)
(commercially available)
@
Make sure that the unit is installed securely I" place. If the unit is
unstable, It may malfunction (for example, the sound may skip).
n Installing in Japanese-Made Cars
1
R&z to the section "Removing the hard
rubber frame" (page 35)
and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
T Toyota cars
N: Nissan cars Accessory@...for Nissan car
Accessory@ . ..for Toyota car
A
l
During installation, do not use any screws except for those provided.
The use of different screws might result In damage to the maln unit.
l
Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
n Screwing the Faceplate on the Unit
If you want to fasten the
faceplate to the main unit so
that it does not fall off,
screw in the provided
screws (04 X 16 mm) in the
holes shown below.
A
Never insert the taptite screw
(04
x 16 mm) in any other screw hole
than the one specified. If you screw it in another hole, it will contact
and may cause damage to the mechanical parts inside the unit.
- 34 -