NAD T 787 Owner's Manual page 30

OPERATION
USING THE T 787 – SETUP MENU
Speaker Setup: from the Speaker Setup menu, go to "Speaker
Configuration" sub-menu and change "Subwoofer" from "On" to "Off":
"Front" becomes "Large"
2 With the above settings, scroll to "A/V Presets" from the SETUP MENU
page. Use [ S ] to access "A/V Presets" menu.
30
3 At "A/V Presets" page, set "Preset: 1" to the following conditions - use
[ D/F ] to select "Yes" or "No" and press [ENTER] to confirm selection
and move on to the next setting.
While at "Save Current Setup to Preset" menu line, use [ S ] to save the
above settings to Preset 1. Below OSD will be shown, affirming that the
above settings are now saved to "Preset 1".
When you recall "Preset 1" using the remote control (for HTR 8, "A/V
PSET" + "1"), the above preset values allocated at "Preset 1" (preset
settings as shown in the OSD captures at Step 1) will be recalled and
effected at the current source.
4 Now, repeat again Step 1 above but this time with the following
settings
Listening Mode: PLIIx Music
DSP Options: 0ms