Connect The Power Cord; And Foot Control 2:2; Connecting The Foot Control Cord - Pfaff performance 5.0 Owner's Manual

and lift off the machine carrying case.
2. Remove all other packing material and the plastic bags.
3. Slide off the accessory tray and remove the styrofoam underneath the free arm.
Note: Styrofoam left in the accessory tray while sewing may affect stitch quality. The styrofoam is for packing
purposes only and should be removed.
performance
Note: Your PFAFF
®
temperature. Extreme hot and cold temperatures can affect the sewn result.
cord. Connecting the foot control cord to the foot
going to use the machine.
1. Take out the foot control cord. Turn the foot
control over. Connect the cord to the socket
inside the open space on the underside of the
foot control as shown.
connected.
3. Pull the cord into the slot to the left of the socket
to ensure that the foot control will rest evenly

Connect the power cord

and foot control
Note: Before plugging in the foot control, check to ensure
that it is type "FR5" (see underside of foot control).
1. Connect the foot control cord to the front socket
on the bottom right side of the machine (A).
2. Connect the power cord to the rear socket on
the bottom right side of the machine (B). Plug
the cord into a wall socket.
3. Press the I/O switch to "I" to turn on power and
light (C).
For the USA and Canada
This sewing machine has a polarized plug (one
blade wider than the other). To reduce the risk
polarized outlet only one way. If the plug does
install the proper outlet. Do not modify the plug
in any way.
2:2
5.0 sewing machine is adjusted to provide the best stitch result at normal room
™
C A B