Eco Menu; Setup Menu - Sharp Aquos LC-32M400X Operation Manual

ECO menu

ECO Setup
No signal off
4
Power management
No operation off
Ecology
H No signal off
You can set the TV to automatically power off in
about 15 minutes after the TV goes into a state of
receiving no programme signals. (Enable, Disable)
• Five minutes before the power shuts down, the remaining
time displays every minute.
NOTE
• When a TV programme fi nishes, and the TV receives
signal input, this function may not operate.
H Power management (PC input mode only)
You can set the TV to automatically power off when
no image is displayed on PC.
Selected item
Off • No power management.
• Factory preset value.
Mode1 • If no signal inputs for approximately
8 minutes, the power shuts down.
• Even if you start using the PC and the
signal inputs again, the TV stays off.
• You can turns on manually by pressing
POWER.
Mode2 • If no signal inputs for approximately
8 seconds, the power shuts down.
• When you start using the PC and the
signal inputs again, the TV turns on
automatically.
• You can turns on manually by pressing
POWER.
H No operation off
You can set the TV to automatically power off when
no TV operation is performed for more than 3 hours.
(30min., 3hr., Disable)
• Five minutes before the power shuts down, the remaining
time displays every minute.
H Ecology
When set to "Yes", the TV activates the following
power saving mode.
• "OPC" set to "On" (Page 12)
• "No signal off" set to "Enable" (Page 13)
• "Power management" set to "Mode1" (Page 13)
• "No operation off" set to "3hr." (Page 13)
• "Quick start" set to "Off" (Page 15).
NOTE
• Ecology mode cannot be deactivated by selecting "No".
Each setting must be changed individually to deactivate
Ecology mode.
Option
[ Enable ]
[ 3hr. ]
Description

Setup menu

Setup Option
Auto installation
4
Analogue programme setup
Digital Programme Setup
Child lock
Input skip
4
Input label
Position
4
HDMI auto view
WSS
4:3 mode
Quick start
Text language
Identification
Reset
H Child lock (ATV and DTV input mode only)
Allows you to use a password to protect certain
settings from being accidentally changed.
Setting a password
Repeat steps 1 to 2 in Menu operation.
1
Press a / b to select "Child lock", and then
2
press ENTER.
3
If you already set the password, enter it here.
Press a / b to select "Change password",
4
and then press ENTER.
5 Enter the 4-digit number as a password
using 0 — 9.
Change password
Clear password
Parental rating
6
Enter the same 4-digit number as in step 5
to confi rm.
NOTE
• To view a locked channel (Lock setting in Analogue
programme setup "Manual adjust" is set to "On"), you
must enter a password. When you select a locked
channel, "Child lock has been activated" is displayed.
• Press ENTER to display the password input window.
Clearing the password
Allow you to clear your password.
Repeat steps 1 to 3 in Setting a password.
1
Press a / b to select "Clear password", and
2
then press ENTER.
3 Press c / d to select "Yes", and then press
ENTER.
Digital setup
[ On ]
[ Panorama ]
[ Off ]
[ West Europe ]
Enter your new password. Use 4 digits
New password – – – –
– – – –
Reconfirm
13