Satellite Radio Tuner Control (Optional); Basic Operation; Category And Channel Search; Direct Access Tuning - Kenwood KDC-X792 Instruction Manual

Satellite Radio tuner control (Optional)
Basic Operation
Selecting Satellite
Radio source
Press the [SRC] button.
Select the "SAr/ "SI RIUS"/ "XM" display.
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
~
~
• You need to register to the service provider to receive
the service by Satellite Radio. Consult the service
provider if"CALL ... TO SUBSCRIBE" appears.
• The radio may take a little time to start receiving after
you select the Satellite Radio source.
• If the signal reception fails, "Acquiring Signal"/ "No Signal"
appears.
Switching
Seek Mode
Press the [AUTO] button.
"Channel"
"Preset"
Select the channel
Push the Control knob towards right or left.
Selecting the
Preset Band
Push the Control knob toward up.
Each time you push the knob, the preset band
alternates between the SR1, SR2, SR3 and SR4.
Channel
Scan
Press the [AUTO] button for at least 2 seconds.
Pressing this button for 2 seconds or longer allows
you to check individual channel for 10 seconds
each. Pressing this button again for 2 seconds or
longer allows you to exit this mode.
Preset Memory
Press the desired [1] - [6] button for at least 2
seconds.
Preset
Tuning
Press the desired [1] - [6] button.
Category and Channel Search
Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the Control knob.
2
Select the Category
Push the Control knob towards up or down.
3
Select the Channel
Push the Control knob towards right or left.
Cancelling
Category and
Channel
Search mode
Press the Control knob.
~
• You cannot Channel search until the category
information is acquired.
Function
of
remote control
Direct Access Tuning
Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the
[~]
or
[~]
button.
Cancelling Direct
Access
Tuning
Press the [DIRECT] button on the remote
control.
G--
~
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"Acquiring Signal"I"No Signal" appears.
26
I
KDC-X792/KDC-X692/KDC-MP738U/KDC-MP638U