2 ] Cu-8011 - Denso BHT-8000 User Manual

[ 2 ] CU-8011

This section describes how to start communication with the host PC in System Mode (FTP).
(1) Turn the host PC on.
(2) Make sure that the AC adapter is plugged into a wall socket and the POWER LED is lit.
(3) Make sure that the BHT is turned off, then put it on the CU-8011.
Ethernet interface
(4) Turn the BHT on and start System Mode. Set up the TCP/IP (device) or FTP (FTP server IP address,
user ID, etc.). Refer to Chapter 2, Section 2.5.3, [4.9].
(5) On the host PC, initiate an FTP server program.
(6) To exchange data by FTP between the BHT and the host PC, select "FTP" on the SYSTEM MENU.
Refer to Chapter 2, Section 2.5.3, [ 7 ].
The BHT and the host PC will start communications with each other via the CU-8011. Upon start of
communication, the DATA LED will come on; after completion of communication, it will go off.
Chapter 5 Handling the CU-8000 (Option)
AC adapter
159