Mount Power Supply Box - Bosch VG5 600 Series Installation Manual

AutoDome 600 Series Analog PTZ Camera
7.
CAUTION!
Select a rigid mounting location to prevent excessive vibration to the AutoDome camera.
2.3

Mount Power Supply Box

Before mounting the Power Supply Box decide if you should wire the box through the holes in
the bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs
to the bottom through the holes before mounting.
NOTICE!
Use 3/4-inch (20-mm) NPS fittings for the holes on the bottom and back of the box. Use 1/2-
inch (15-mm) NPS fittings for the side holes.
Figure 2.1 Power Supply Wall, Mast (Pole), and Corner Mounts
1.
2.
WARNING!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265 lb)
pull-out force is recommended. The mounting material must be able to withstand this pull out
force. For example, 19-mm (3/4-inch) minimum for plywood.
Bosch Security Systems, Inc.
Purchase the appropriate mounting hardware to use, depending on the location of the
AutoDome, either wall mount, corner mount, or mast (pole) mount.
If you application contains a Power Supply Box, refer to Section 2.3 Mount Power Supply
Box, page 15.
If you are using the Mounting Plate with a 24 V VG5 AutoDome, refer to
Section 2.8 Installing the VG4-A-ARMPLATE, page 27.
Use the wall mount template supplied in the packaging box to locate the four (4)
mounting holes for the Power Supply Box.
Drill four (4) holes for the mounting anchors. If installing outdoors, apply a weatherproof
sealant around each hole at the mounting surface.
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 15
F.01U.265.793 | 2.0 | 2012.02