Specifications - Bosch Solution 16plus Quick Start Manual

Communication Test
Use MENU 5-9-0 to test the telephone reporting capability
of the control panel. You can also activate a communication
test by holding down the Test / Mail key on the keypad.
S pe ci fic ati on s
Voltage Input
Current Requirements
Power Outputs
Continuous Power
Secondary Source
Stand-by Battery
Min Operating Voltage
Discharge Cycle
AC Off
13.8 VDC
11.5 VDC
10.0 VDC
Recharge Cycle
AC On
13.0 VDC
13.8 VDC
LAN BUS
Telephone Connections
Temperature
Relative Humidity
Compatible Keypads
Compatible Accessories
Enclosure Dimensions:
PWA Dimensions:
Warranty:
The following parts are supplied with the panel
(Australian models only - content may differ in export models )
Panel Assembly Includes
Resistor Pack Includes
Available Separately
Bosch Security Systems 09/06 BLCC100R
Panel Solution 16 (Part Number CC100)
plus
16-22 VAC
22 VA min plug pack adapter or transformer
1 Amp (Primary supply source only)
4 Amp (Total with both primary and secondary source combined)
12 VDC, 7AH sealed rechargeable battery
10.2 VDC
Keypads indicate trouble condition, AC Fail report sent (if programmed)
Charging level
Low battery trouble at keypads, low battery report sent (if programmed)
Panel shuts down as voltage fails below 10.2 VDC
Panel restarts, battery charging begins.
AC trouble clears from keypads,
AC restore report sent (if programmed).
Battery trouble clears from keypads,
Battery restore report sent (if programmed).
Battery pulse charged.
12 VDC, 305M of 14/0.20 0.8mm2 (22 AWG) cable.
RJ-12 Socket or 4-way terminal
0˚ to 55˚ C
5 to 85% at 30˚C non-condensing.
CP100 Graphic
CP101 Graphic + Prox
CM104 8/16 Zone Expander
CM110 4-Way Relay Output Module
CM120 1-Amp LAN Power Supply
375mm (W), 257mm (H), 90mm (D)Part Number: MW100
235mm (W), 40mm (H), 85mm (D)
3 years from date of manufacture (return to base)
1 x Metal Enclosure with tamper
1 x Panel PWA
1 x User Manual
1 x Red Battery Lead
1 x Black Battery Lead
1 x 2-Way Shunt With Handle
2 x Phillips Pan Head Zinc Plate Screw
1 x Telephone Cable RJ12 6P/4C
10 x 3K3 – 0.25W +/- 1% Metal Film Resistors
10 x 6K8 – 0.25W +/- 1% Metal Film Resistors
1 x 3-Way AC Terminal Block
1 x Panel Tamper Switch
1 x Tamper Switch Bracket
Solution 16 Installation Manual Part Number: BLCC100I
plus
Solution Link (RAS) Software Part Number: SW500B
Solution 16
CP110 Graphic - Black
CP111 Graphic + Prox - Black
CM195 Multi RF Receiver Interface
SW500B Solution Link (RAS) Software
CM900 Direct Link Interface
1 x Installer Reference Guide
1 x Resistor Pack
Quick Start Guide
plus
33