Wireless Remote Controller - LG ATNH126ELFB Service Manual

Optional Function

• Wireless Remote Controller

This air-conditioner is equipped with wired remote controller basically. But if you want to have the wireless remote controller,
you pay for it.
Signal transmitter
Transmits the signals to the signal receptor.
1
4
3
5
6
CAUTION :
for handling the Remote Controller
• Aim at the signal receptor on the wired remote controller so as to operate.
• The remote control signal can be received at a distance of up to about 7m.
• Be sure that there are no obstructions between the remote controller and the signal receptor.
• Do not drop or throw the remote controller.
• Do not place the remote controller in a location exposed to direct sunlight, or near the heating unit, or any other heat
source.
• Block a strong light over the signal receptor with a curtain or etc. so as to prevent the abnormal operation. (ex:elec-
tronic quick start, ELBA, inverter type fluorescent lamp)
11
A/CL
10
9
2
7
8
1. FAN Operation Button
Used to circulate room air without cooling or heat-
ing.
2. Cooling Operation Button
3. Soft Dry Operation Button
Used to dehumidify without overcooling.
4. Heating Operation Button
(Heat pump model only)
5. Timer Set Button
Used to set the timer when the desired time is
obtained.
Then the wired remote controller is set up to 24
hours by an hour but the wireless remote controller
is set up to 7 hours by an hour. Therefore, if you
want to set over 7 hours, use the wired remote
controller.
6. Fan Speed Button
Used to set the desired fan speed.
7. On/Off Button
Operation starts when this button is pressed, and
stops when the button is pressed again.
8. Set Temperature Button
Used to set the temperature when the desired tem-
perature is obtained
9. Auto Operation Button
10. Plasma Air Clean Button(Optional)
11. Electric Heater Button(Optional) Used to set the
Electric Heater.
Ceiling Concealed Duct
Service Manual 65