LG ATNH126ELFB Service Manual page 29

8.5 Installation of Decoration Panel(Elevation Grille)
The decoration panel has its installation
direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by
amount 10mm in length.)
The fixing screws (hexagon M5 screw) are included unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector display connector, elevation grille connector and power supply con-
nector
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decoration panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Inlet Grille Inlet Grille
Louver motor
Decoration panel
Display
Before installing the decoration panel,
always remove the paper template.
) on the screws fixed in step above, and slide the panel so
Piping side
Key holes
Decoration panel fixing screws
(Hexagon M5 screw)
Ceiling Cassette 4-way
Control box cover
Inlet grille
Service Manual 33